• TPI 725L Combustible Gas Leak Detector

In a clean air environment, press the ON/OFF key to turn the 725L on. Both LED’s will flash as the unit initializes and auto zeroes. When the green LED above the ON/OFF switch flashes and a tick is heard the 725L is ready for use. Trace gas lines, fittings, tanks, and containers for leaks.

Approach suspected leak areas with the sensor. When a leak above 40ppm is detected the 725L tick and green LED flash rate will increase. When the tick rate increases press and release the ON/OFF key to nullify the tick and continue to approach the suspected leak area with the sensor. Continue to nullify the tick when the rate increases until the location of the leak is found. If the tick slows or stops on its own the concentration level has decreased. Move back in the opposite direction to find the leak again. If the leak reaches 1000ppm or above the high LED will illuminate (see below).

 Model 725L Specifications
 Sensitivity > 40ppm Methane
 Operating Temp 32° to 104°F or 0° to 40°C
 Response Time Instantaneous
 Battery 1.5 volt, AAA Alkaline (2 each)
 Battery life 3 hours continuous use



Download datasheet

Write a review

Note: HTML is not translated!
    Bad           Good

TPI 725L Combustible Gas Leak Detector

  • Product Code: 725L
Minta Penawaran

Tags: TPI, 725L, Combustible, Gas, Leak, Detector